Tuf-Trim Hi Performance W/B Trim Paint

Home :: Decorative Products :: Tuf-Trim Hi Performance W/B Trim Paint
Tuf-Trim Hi Performance W/B Trim Paint

TUF-TRIM HI PERFORMANCE W/B TRIM PAINT WATER-BASED Less than 60 GPL VOC !

A single component, gloss low VOC pigmented acrylic coating based on Nano Technology, TUF-TRIM demonstrates outstanding adhesion to Latex, Alkyd and Urethane coatings with proper preparation, WITHOUT PRIMING!!! . May be used interior and exterior on trim, doors, hand rails, metal door and window frames. Fast no block times for quick return to service

TUF-TRIM is Best Used for

  • INTERIOR & EXTERIOR, WOOD ,METAL, COMPOSITE

  • ADHERES TO LATEX ,ALKYD, URETHANE ,EPOXY AND KYNAR

  • USE ON TRIM, DOORS, HANDRAILS, DOOR AND WINDOW FRAMING
SKU TUF-TRIM
 
Our price:
Quantity

Technical Information

Technical Data (White):

COVERAGE150-350 sq. ft./gal depending on porosity and texture of substrate
DILUENTWater
CLEAN-UPSoap and Water
VOC CONTENT < 50 GR/LITER
ODORSlight
APPEARANCECOLOR DEPENDENT
GLOSSSatin or High Gloss
LIGHT STABILITYExcellent
DURABILITYExcellent
WATER RESISTANCEExcellent
TENSILE STRENGTHExcellent
BONDINGExcellent
CLEANABILITYExcellent

LIMITATION OF LIABILITY: The Manufacturer and/or the Seller warrants that if any goods supplied prove defective in workmanship ormaterial, that Manufacturer and/or Seller shall replace them or refund the purchase price. This warranty is made in lieu of any and all otherwarranties expressed or implied. Before application, the User shall determine the suitability of the product for his intended use and User assumes allrisks and liabilities whatsoever in connection therewith. Under no circumstances shall the Manufacturer and/or Seller be liable for incidental, consequentialor other damages for alleged negligence, breach or warranty, or strict liability arising out of use or handling of this product. The sole liabilityof Manufacturer and/or Seller for any claims arising out of the use of sale of the product shall be for the User’s purchase price.

Usage Information

Preparation:

Dirt,oil, grease, mold and mildew, and any other contaminates must be removed from the surface to insure that the paint has good contact with thesubstrate. Remove oil, grease, and any othercontaminants with strong detergent, TSP, or degreasers and rinse thoroughly. Make certain algaeor mildew is treated with bleach and rinsed thoroughly. Scuff sand existing coatings with 220-320 grit paper or coarse scuff pads.

Application:

Apply with a high quality brush, 1/4 to 3/8” microfiber roller or HVLP sprayer. Apply from dry to wet. Two coats may be required.

Limitations:

  • Do not apply when air or surface temperatures are below 50°F(10°C) or are expected to fall there before coating can dry.
  • Do not apply to a wet or damp surface or within 6 degrees of the dew point
  • Do not apply when it may rain or if dew may condense on the surface before the coating will have a chance to dry.
  • Do not allow to freeze. Store above 38°F

Drying Time:

Normally dries to touch in 1-3 hours and will be block resistant after 3-5 hours drying at 70f deg. plus. High humidity or heavy application mayextend drying and block resistance times